Re: bandit interface
Posted by
arturodu
on 2002-04-13 08:53:00 UTC
--- In CAD_CAM_EDM_DRO@y..., "conmach" <conmach@y...> wrote:
I just connected my Bandit I to my computer and works great. You
first need the 28Amp connector, since I did not have it; I replaced
the wiring to a 25D connector. You need to tie pins 15,17, and 24.
Tie also 10, 16, and 23. Then you can use this port as a standard
rs232. Communication is at 110-baud 7bit.
Good Luck
Arturo Duncan
> i would like to connect my pc to a ab bandit control. what little iDC,
> know about this hooks the cable,pre wired, to com1 port and then
> wires the rs 232 i/o port on the control.what i don't have is the
> wiring diagram for the rs 232 plug. any help on this would be great
> thanks dc.
I just connected my Bandit I to my computer and works great. You
first need the 28Amp connector, since I did not have it; I replaced
the wiring to a 25D connector. You need to tie pins 15,17, and 24.
Tie also 10, 16, and 23. Then you can use this port as a standard
rs232. Communication is at 110-baud 7bit.
Good Luck
Arturo Duncan
Discussion Thread
conmach
2002-04-12 16:19:45 UTC
bandit interface
arturodu
2002-04-13 08:53:00 UTC
Re: bandit interface
imserv1
2002-04-13 12:55:55 UTC
Re: bandit interface