General info
Posted by
smc51900
on 2002-04-25 22:29:51 UTC
Hi!
I was wondering if you guys could help me out. I am trying to
build a CNC router, and I've come upon a few problems. First, where
can I get a GOOD power supply? Next, what is the general opinion no
the software ou there? (Master5, EMC, DesKAM etc.) Which is the most
user friendly, cost effective and efficient? I don't mind spending a
couple hundred dollars on DECENT software, I just don't want to end
up investing in something I can't use. The same thing goes with CAM
packages.
Thanks in advance.
Seth
I was wondering if you guys could help me out. I am trying to
build a CNC router, and I've come upon a few problems. First, where
can I get a GOOD power supply? Next, what is the general opinion no
the software ou there? (Master5, EMC, DesKAM etc.) Which is the most
user friendly, cost effective and efficient? I don't mind spending a
couple hundred dollars on DECENT software, I just don't want to end
up investing in something I can't use. The same thing goes with CAM
packages.
Thanks in advance.
Seth