BDI and encoders.
Posted by
webstercnc@a...
on 2002-05-22 10:09:25 UTC
Hi everyone,
(This is all new to me but I'm hanging in there.)
I'm using the BDI for EMC version 2.12
and I have steppers, encoders,
camtronics DRO board, and camtronics
5amp driver boards.
I want to use my encoders but I don't
know for sure what I need to change
in the generic .ini file to make them work.
Can someone guide me to the right direction
and show me what I need to do.
thank you in advance,
Juan
[Non-text portions of this message have been removed]
(This is all new to me but I'm hanging in there.)
I'm using the BDI for EMC version 2.12
and I have steppers, encoders,
camtronics DRO board, and camtronics
5amp driver boards.
I want to use my encoders but I don't
know for sure what I need to change
in the generic .ini file to make them work.
Can someone guide me to the right direction
and show me what I need to do.
thank you in advance,
Juan
[Non-text portions of this message have been removed]