CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Geckos. 201 or 210?

Posted by John
on 2002-06-24 03:57:07 UTC
> You should be able to salvage the power supply, but it may not be in the
right range
> for a Gecko or other bipolar drive to perform at its best. Unipolar R-L
drives
> generally used the absolute minimum voltage possible to reduce the heat
produced
> by the big power resistors.

Thanks,

Why do servos run on encoders mounted in the belt or rotor instead of
always using something like a capacitive strip on the ways? That's totally
limited backlashing down to the accuracy the strip could be read. I mean,
the encoder gives the position of the rotor but not the table. Does it
create problems with the machine trying to find the right spot for the table
to be in? Or is it just more expensive? : )

Regards,
John

Discussion Thread

John 2002-06-23 10:26:13 UTC Geckos. 201 or 210? Jon Elson 2002-06-23 22:22:33 UTC Re: [CAD_CAM_EDM_DRO] Geckos. 201 or 210? John 2002-06-24 03:57:07 UTC Re: [CAD_CAM_EDM_DRO] Geckos. 201 or 210? turbulatordude 2002-06-24 04:32:37 UTC Re: Geckos. 201 or 210? Jon Elson 2002-06-24 10:32:03 UTC Re: [CAD_CAM_EDM_DRO] Geckos. 201 or 210?