CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Motor sizing

on 2002-06-29 16:52:34 UTC
On Sat, 29 Jun 2002 19:12:38 -0000, you wrote:


>I think I read somewhere it only takes 10lbs of force to rout a piece
>of wood with a 1/2" cutter, 3/4" deep, at 3"/min feed?

Surely that depends on the cutters rotational speed?

Would you really cut that slow on wood? A commercial Komo machine I
saw was running at 3000 inches a minute! Frightening!!!

Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net

Discussion Thread

cdoughtynz 2002-06-28 22:55:10 UTC Motor sizing dakota8833 2002-06-29 05:56:07 UTC Re: Motor sizing cdoughtynz 2002-06-29 12:12:40 UTC Re: Motor sizing Bob Campbell 2002-06-29 13:34:08 UTC RE: [CAD_CAM_EDM_DRO] Motor sizing Steve Blackmore 2002-06-29 16:52:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor sizing cdoughtynz 2002-06-29 17:30:12 UTC Re: Motor sizing JanRwl@A... 2002-06-29 22:09:50 UTC Re: [CAD_CAM_EDM_DRO] Motor sizing andrewyslee 2002-06-30 00:07:16 UTC camtronics vs gecko Tim Goldstein 2002-06-30 13:17:23 UTC RE: [CAD_CAM_EDM_DRO] camtronics vs gecko andrewyslee 2002-07-01 02:39:56 UTC Re: camtronics vs gecko Tim Goldstein 2002-07-01 12:17:12 UTC Re: [CAD_CAM_EDM_DRO] camtronics vs gecko alenz2002 2002-07-01 16:00:07 UTC Re: camtronics vs gecko Jon Elson 2004-02-13 09:56:54 UTC Re: [CAD_CAM_EDM_DRO] Motor sizing