Re: I need help with hp7470a plotter
Posted by
cncnovice
on 2002-07-20 21:54:50 UTC
I don't think you need to connect these two wires, that's why there
listed as they are. Try the cable without them.
Good luck,
John
listed as they are. Try the cable without them.
Good luck,
John
--- In CAD_CAM_EDM_DRO@y..., "mlpapus1" <mlpapus1@h...> wrote:
> Hello all
> I have a hp7470a plotter and it pass all the test when i start it.
> I am trying to wire a new cable 25-pin to 9-pin and i dit what they
> show in this link :
> http://www.hp.com/cposupport/plotters/support_doc/bpp01379.html
> I have a question to where to conect the pin #6 from the 25-pin to
> 9-pin conector,the info show #6-pin from plotter data set redy to |
> look like this :data set redy 6--| ,what this means ??
> Also the #8 pin from the 9-pin conector show the same
> : |--8 clear to send
> Where should i conect this two wires ?????
> Thanks
> Papas
Discussion Thread
mlpapus1
2002-07-20 21:40:20 UTC
I need help with hp7470a plotter
cncnovice
2002-07-20 21:54:50 UTC
Re: I need help with hp7470a plotter