Gecko Amps ?
Posted by
turbulatordude
on 2002-08-06 16:01:02 UTC
Hi all,
I have a 201 rev A and am looking to use a small stepper. a NEMA23,
5 volt, 1.5 amp, 6 wire Vexta.
series connection would use 3/4 amp, but the notes I have list 1.0 A
as the minimum.
Since I have a 6V 0.8A also, the solution is not just parallel
connection.
so the question is will the rev A will work at a lower amperage?
Dave
I have a 201 rev A and am looking to use a small stepper. a NEMA23,
5 volt, 1.5 amp, 6 wire Vexta.
series connection would use 3/4 amp, but the notes I have list 1.0 A
as the minimum.
Since I have a 6V 0.8A also, the solution is not just parallel
connection.
so the question is will the rev A will work at a lower amperage?
Dave