OT - machinery
Posted by
Dave Engvall
on 2002-08-07 16:49:59 UTC
Hi,
Any one need a 20" shaper, flat belt drive.?
Unless you really need a shaper the best use would seem to be a surface
grinder. Slowly run the ram (with grinding wheel spindle) back and forth
while rotating the work below it.
The other thing I have is a Perkin-Elmer graphite furnace....for an atomic
absorbtion. Think about a current supply capable of resistance heating a
3/4" or so graphite tube to 2800 degrees in a sec. These are rumored to make
good welders. I've had it for years and not done anything with it.
Time someone else gets a shot at it. Probably 300 lbs but on casters.
I'm in central Washington, think Yakima....this stuff is probably not worth
shipping.
Please reply off-list to dengvall@....
Thanks.
Dave
Any one need a 20" shaper, flat belt drive.?
Unless you really need a shaper the best use would seem to be a surface
grinder. Slowly run the ram (with grinding wheel spindle) back and forth
while rotating the work below it.
The other thing I have is a Perkin-Elmer graphite furnace....for an atomic
absorbtion. Think about a current supply capable of resistance heating a
3/4" or so graphite tube to 2800 degrees in a sec. These are rumored to make
good welders. I've had it for years and not done anything with it.
Time someone else gets a shot at it. Probably 300 lbs but on casters.
I'm in central Washington, think Yakima....this stuff is probably not worth
shipping.
Please reply off-list to dengvall@....
Thanks.
Dave