RE: [CAD_CAM_EDM_DRO] bitscope etc

Hi,

I've had a bitscope for a number of years and am very happy with it. I
especially like the mixed mode function where both logic and analog signals
can be displayed simultaneously.

I have used it to observe jitter problems in stepper pulse streams from the
parallel port with some software. I've also used it to debug a step/dir to
phase drive converter board.

Cheers,


Peter Homann
mailto:Peter.Homann@...
Adacel Technologies Limited,
250 Bay St, BRIGHTON, 3186, AUSTRALIA
http://www.adacel.com <http://www.adacel.com>
Telephone +61 (3) 8530 7777, Facsimile +61 (3) 9596 2960
Mobile 0421-601 665


-----Original Message-----
From: funcnc2002 [mailto:funcnc2002@...]
Sent: Tuesday, 20 August 2002 2:41 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] bitscope etc


Hi,

Been following the discussion about stepper problems, pulse source
and cable shielding with interest, and I have similar problems. I am
thinking of adding some equipment like the bitscope

http://www.bitscope.com/

perhaps even an affordable oscilloscope if I can find one, to do some
trouble-shooting. For a person who is comfortable with science, but
is not an electronics man would adding those equipment be of any
help? or would I be better off with just a simple logic probe?

Talking of logic probe, anyone has built one themself?

Thanks

lee



Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this as a sister
site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Mom
List Owner



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/