CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Gecko Servo Control

Posted by Larry Ragan
on 2002-08-21 07:26:03 UTC
Hello:
I have done this on my knee mill. I had an anilam cnc control that died and
I used the scales that were on the machine. I am using Gecko 340 drives with
the original servo motors. You need to make sure that there is very little
backlash. My system has ballsrews on all 3 axis and the y axis would
oscialte rapidly. There was about .001 play in the screw mounts and until
this was removed it would shake the machine pretty violently. It can be
done and does work quite well but any slop between the motor and the encoder
will result in this osciallation.
Regards
Larry Ragan

-----Original Message-----
From: astrehler [mailto:deruhrmacher@...]
Sent: Wednesday, August 21, 2002 8:02 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Gecko Servo Control


Hello

Is it possible to connect a linear encoder on the slides
instead of an angular encoder on the motor.
I would like to increase the accuracy of the machine this way,
because this would eliminate pitch errors of the screws.
I know that some "big" machines works like this.
Does it work with a Gecko too?

Regards
Andreas, the watchmaker


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this as a sister
site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Mom
List Owner



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

astrehler 2002-08-21 07:01:54 UTC Gecko Servo Control Larry Ragan 2002-08-21 07:26:03 UTC RE: [CAD_CAM_EDM_DRO] Gecko Servo Control Jon Elson 2002-08-21 14:12:18 UTC Re: [CAD_CAM_EDM_DRO] Gecko Servo Control