Another interesting low-cost solid modeler
Posted by
thomasm923@a...
on 2002-08-26 20:47:37 UTC
A little while ago I got this in my inbox (see below). Inovate is a
stand-alone solid modeler, not a Rhino plug-in, so some of you non-Rhino
users may be interested, too. Looks very impressive. There is a 30 day trial
and a fairly good tutorial at their site.
-Tom M
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
RHINO PRESS RELEASE - 7 August 2002
IronCAD brings mechanical solid modeling to Rhino users
Atlanta, GA, August 7, 2002 - IronCAD, LLC., announced a
Rhino/Inovate bundle for US$ 1,690 (save $500). IronCAD is
also offering Inovate to Rhino users for $895 (save $400).
These special prices are for a limited time only. For details,
visit: http://www.ironcad.com/rhino
The combination of Rhino and IronCADÂ’s Inovate mechanical solids
modeling software provides product designers with significant
productivity improvements over using each product alone.
stand-alone solid modeler, not a Rhino plug-in, so some of you non-Rhino
users may be interested, too. Looks very impressive. There is a 30 day trial
and a fairly good tutorial at their site.
-Tom M
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
RHINO PRESS RELEASE - 7 August 2002
IronCAD brings mechanical solid modeling to Rhino users
Atlanta, GA, August 7, 2002 - IronCAD, LLC., announced a
Rhino/Inovate bundle for US$ 1,690 (save $500). IronCAD is
also offering Inovate to Rhino users for $895 (save $400).
These special prices are for a limited time only. For details,
visit: http://www.ironcad.com/rhino
The combination of Rhino and IronCADÂ’s Inovate mechanical solids
modeling software provides product designers with significant
productivity improvements over using each product alone.