Re: Stepper Controls
Posted by
Bob Bachman
on 1999-05-08 17:45:48 UTC
Dennis and all,
The card from Boondog is a parallel port card with 3 ports. Very easy to
use for
experimenting. Good documentation. URL = http://www.boondog.com
The stepper driver from Space Time Productions has been a disappointment so
far. The
card is well made but except for a schematic of the board, documation is
nonexsistant.
Simon has been good at returning my email questions, but his software to
run his
board is written in Forth. I have some 450 oz/in motors which need 3.5v @
3.5a that
I want to use on the bp clone. I have one installed one the X axis with a 2
to 1
reduction and the best table speed I can get is ~8 ipm. Pretty slow for
positioning.
I'm running it with a simple Qbasic prog. The timing loop is a short as I
can get it
without motor chatter (~60rpm). I'm open to suggestions. Simon's URL =
http://www.tefbbs.com/spacetime/index.html
Dan Mauch's driver card would be great but I don't think it will handle
these low
voltage motors.
Bob
At 09:12 AM 5/8/99 -0500, you wrote:
The card from Boondog is a parallel port card with 3 ports. Very easy to
use for
experimenting. Good documentation. URL = http://www.boondog.com
The stepper driver from Space Time Productions has been a disappointment so
far. The
card is well made but except for a schematic of the board, documation is
nonexsistant.
Simon has been good at returning my email questions, but his software to
run his
board is written in Forth. I have some 450 oz/in motors which need 3.5v @
3.5a that
I want to use on the bp clone. I have one installed one the X axis with a 2
to 1
reduction and the best table speed I can get is ~8 ipm. Pretty slow for
positioning.
I'm running it with a simple Qbasic prog. The timing loop is a short as I
can get it
without motor chatter (~60rpm). I'm open to suggestions. Simon's URL =
http://www.tefbbs.com/spacetime/index.html
Dan Mauch's driver card would be great but I don't think it will handle
these low
voltage motors.
Bob
At 09:12 AM 5/8/99 -0500, you wrote:
>From: "Dennis Mino" <dmino@...>
>
>Bob, Can you share the web pages for Space Time Prod. and Boondog? I am
>interested in some stepper boards.....
>Thanx.
>
>
>> Been experimenting with a stepper driver board from Simon at Space-Time
>> Prod. and
>> a parallel port board from Boondog.
>>
Discussion Thread
Bob Bachman
1999-05-08 17:45:48 UTC
Re: Stepper Controls
Brian Fairey
1999-05-09 04:45:52 UTC
Re: Stepper Controls
Bob Bachman
1999-05-09 09:09:08 UTC
Re: Stepper Controls