Added photos- Rick-O-Matic
Posted by
dodge1320
on 2002-09-10 21:01:32 UTC
Added a few more photos. Photos- Rick-o-Matic folder
(2) sme career fair at MCCC
(1) dremel spindle
(1) vibrating engraving head (engraver has a squarish shank,wrapped
with a piece of car innertube for "flex")
(1) belt drive settup 3-1 made em myself'!
Also note: y axis motor hanging under belt drive. I like
handwheels on my stuff!
(1)Dodge Nascar blocks. Been doing these for over 2 years!!!!!!!! I
have personally worked on Every one in the Dodges. Ok, so it's my
only claim to fame. Well that was a short 15 minutes! LOL
(1) some things I had laying around that I engraved(I make a lot of
things to give away, these were, uh, not quite right ones.
Cnc specs: Hobbycnc.com Board and motors
Enco x/y cast iron table
Z stage, base,top plate with tapped holes- Home made
McMaster-Carr Ball screw stock and nuts (5/8")
Secondwindpcs.com Used computer, 450 p2 IBM ($212.00!)
Kcam, iradicator(speeds up machine), Master5,corel
3,Deskengrave,quickcad and? (software) More later, Rick
(2) sme career fair at MCCC
(1) dremel spindle
(1) vibrating engraving head (engraver has a squarish shank,wrapped
with a piece of car innertube for "flex")
(1) belt drive settup 3-1 made em myself'!
Also note: y axis motor hanging under belt drive. I like
handwheels on my stuff!
(1)Dodge Nascar blocks. Been doing these for over 2 years!!!!!!!! I
have personally worked on Every one in the Dodges. Ok, so it's my
only claim to fame. Well that was a short 15 minutes! LOL
(1) some things I had laying around that I engraved(I make a lot of
things to give away, these were, uh, not quite right ones.
Cnc specs: Hobbycnc.com Board and motors
Enco x/y cast iron table
Z stage, base,top plate with tapped holes- Home made
McMaster-Carr Ball screw stock and nuts (5/8")
Secondwindpcs.com Used computer, 450 p2 IBM ($212.00!)
Kcam, iradicator(speeds up machine), Master5,corel
3,Deskengrave,quickcad and? (software) More later, Rick