Denford starturn 8 Software
Posted by
alastairseggie
on 2002-09-14 11:19:17 UTC
Hi All I have a denford Starturn 8 and I am looking for the software.
Here are some of the specs, I have got a lot of in formation on this
machine down to electronics level. I even have the eprom for this
machine and a BBC computer but I have not been able to find the
software. Now there were two models one that used the RS423 the other
used the 1MHz bus. The one I have uses the 1MHz bus. Any Help Would
be apprieciated.
Electrical
Supply: 50/60 Hz 1 phase 220/240 volts
Spindle motor: 1/2 H.P. DC permanant magnet
Stepper motors 200 steps /rev DC2.9V 3.8A
Serial no. ST06036 C
Model Starturn 8
Date of manafacture March 1986
Serial No of control 180386
On the back of the bed 69 48 111 EACU 4133620
Number on bed slideway P279A
The interface board Syntel 1985 SST1 issue C
Stepper drivers: PKS Digiplan, Prod No SD3, MFG No 1322.009 Serial
Nos TN2789/047 & TN2789/007.
Here are some of the specs, I have got a lot of in formation on this
machine down to electronics level. I even have the eprom for this
machine and a BBC computer but I have not been able to find the
software. Now there were two models one that used the RS423 the other
used the 1MHz bus. The one I have uses the 1MHz bus. Any Help Would
be apprieciated.
Electrical
Supply: 50/60 Hz 1 phase 220/240 volts
Spindle motor: 1/2 H.P. DC permanant magnet
Stepper motors 200 steps /rev DC2.9V 3.8A
Serial no. ST06036 C
Model Starturn 8
Date of manafacture March 1986
Serial No of control 180386
On the back of the bed 69 48 111 EACU 4133620
Number on bed slideway P279A
The interface board Syntel 1985 SST1 issue C
Stepper drivers: PKS Digiplan, Prod No SD3, MFG No 1322.009 Serial
Nos TN2789/047 & TN2789/007.