CAD CAM EDM DRO - Yahoo Group Archive

Re: 5'x20' router

Posted by byrogyro69
on 2002-10-01 22:37:59 UTC
So 20' of cable necessary to run from the drives to the motors will
not cause a problem? I.E. voltage drop, lost data bits?



CAD_CAM_EDM_DRO@y..., "Robert Campbell" <bob@c...> wrote:
> Byron,
>
> Depending on the gearing, you should be able to do 200 to 300
IPM. It will
> also depend on the control program.
>
> Bob Campbell
> ----- Original Message -----
> From: "Byron Hatfield" <byronhatfield@h...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Tuesday, October 01, 2002 2:03 PM
> Subject: [CAD_CAM_EDM_DRO] 5'x20' router
>
>
> > I am planning on building a 5" x 20" router / plasma cutting cnc
machine
> and
> > was wondering how far i can run my stepping motors from the
drives? I am
> > planning on using the Gecko G210's for for my drives. Any info
would be
> > appreciated.
> >
> >
> >
> >

Discussion Thread

Robert Campbell 2002-10-01 14:17:24 UTC Re: [CAD_CAM_EDM_DRO] 5'x20' router Lloyd Leung 2002-10-01 19:00:10 UTC RE: [CAD_CAM_EDM_DRO] 5'x20' router byrogyro69 2002-10-01 22:37:59 UTC Re: 5'x20' router dazedNconfused 2002-10-02 00:46:06 UTC Re: [CAD_CAM_EDM_DRO] Re: 5'x20' router