Re: Re: Re: Home/Limit switches : Micro switches or optical > interrupters?
Posted by
Ray Henry
on 2002-10-02 04:44:13 UTC
The Hardinge CHNC lathes had a magnet imbedded in the large drive pulley.
It pulled a hall switch for fine home. There was also a snap switch for
coarse home. These used resolvers rather than encoders and didn't have
an index pulse.
Ray
It pulled a hall switch for fine home. There was also a snap switch for
coarse home. These used resolvers rather than encoders and didn't have
an index pulse.
Ray
> From: Marv Frankel <dcdziner@...>
> Subject: Re: Re: Home/Limit switches : Micro switches or optical
> interrupters?
>
> Ed,
> You better be machining non-ferrous materials exclusively, if
> you're mounting magnets on the table, or figure out a way to keep chips
> and cuttings from accumulating on the magnets. I have that problem with
> my magnet coolant mister, and that's not critical at all.
>
> Marv Frankel
> Los Angeles
Discussion Thread
Ray Henry
2002-10-02 04:44:13 UTC
Re: Re: Re: Home/Limit switches : Micro switches or optical > interrupters?