CAD CAM EDM DRO - Yahoo Group Archive

limit/home switches

Posted by awallin25
on 2002-10-06 08:19:47 UTC
Hi,
I have a 3d router table with only limit switches (+ and -)
installed, no separate home switches.
I'm going to use EMC to control the stepperdrives.

I'm thinking about wiring the - limit switches as the home switches
and using the + switches as limit switches.

Would this be dangerous ? eg. the controller could drive the axes
past home...
is it possible to wire the -limits to both the emc -limit and the
home input ??

AW

Discussion Thread

Matthew King 2001-09-18 13:19:27 UTC limit/home switches Tim 2001-09-18 14:07:52 UTC RE: [CAD_CAM_EDM_DRO] limit/home switches William Scalione 2001-09-18 14:24:59 UTC Re: [CAD_CAM_EDM_DRO] limit/home switches Jon Elson 2001-09-18 21:40:48 UTC Re: [CAD_CAM_EDM_DRO] limit/home switches Matthew King 2001-09-19 00:09:08 UTC Re: [CAD_CAM_EDM_DRO] limit/home switches awallin25 2002-10-06 08:19:47 UTC limit/home switches