Re: [CAD_CAM_EDM_DRO] DRO interface circuit
Posted by
James Stevens
on 2002-10-14 09:42:10 UTC
Larry,
I haven't implemented one, but I did the research and put the spec from
Mitutoyo here:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/digimatic/Spec/
HTH,
James
I haven't implemented one, but I did the research and put the spec from
Mitutoyo here:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/digimatic/Spec/
HTH,
James
----- Original Message -----
From: "Larry Goldberg" <l_j_goldberg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, October 14, 2002 11:10 AM
Subject: [CAD_CAM_EDM_DRO] DRO interface circuit
> I thought I had seen a schematic and logic diagram of the four pin
> interface used in Mitutoyo calipers, scales, and Chinese copies. A
> search of the archives was unsuccessful.
>
> Has anyone interfaced directly to these devices, and used them for
> closed loop control? Could you post the information or a link to it?
>
> Thanks,
>
> Larry
Discussion Thread
Larry Goldberg
2002-10-14 09:10:41 UTC
DRO interface circuit
James Stevens
2002-10-14 09:42:10 UTC
Re: [CAD_CAM_EDM_DRO] DRO interface circuit
Steven J. Devine
2002-10-14 11:08:41 UTC
Re: [CAD_CAM_EDM_DRO] DRO interface circuit
vrsculptor
2002-10-14 11:25:16 UTC
Re: DRO interface circuit Chinese NOT Mitutoyo!