Update...dropped servo motor fixed
Posted by
mueller914
on 2002-10-24 12:41:23 UTC
a while back I dropped one of my servo motors which caused 3 of the 4
magnets to become unglued from the case of the motor.
This morning I glued them back on with Loctite 9414 adhesive
(had a sample of this stuff laying around for some reason)
So far so good, I just ran the motor with 24v for a few minutes
(both directions)
I guess the real test will be tonight when I hook it up to my mill
and put some current into it.
Mike
magnets to become unglued from the case of the motor.
This morning I glued them back on with Loctite 9414 adhesive
(had a sample of this stuff laying around for some reason)
So far so good, I just ran the motor with 24v for a few minutes
(both directions)
I guess the real test will be tonight when I hook it up to my mill
and put some current into it.
Mike