Refitting a Lynx
Posted by
hllrsr@c...
on 2002-11-03 12:33:23 UTC
Guys,
I have a chance at getting a good deal on a burning table but am in need
of some help.
The rig is an Union Carbide CS-56 table with the original GE amps left
on it, and a Lynx Technologies controller scabbed onto it.
The GE amps are smoked and I need to know what (if anything) would be a
reasonably easy hook up to replace them?
Geckos?
The motors are Balder dc servos at approx 80 volt, 5A.
Any help greatly appreciated.
Iain
I have a chance at getting a good deal on a burning table but am in need
of some help.
The rig is an Union Carbide CS-56 table with the original GE amps left
on it, and a Lynx Technologies controller scabbed onto it.
The GE amps are smoked and I need to know what (if anything) would be a
reasonably easy hook up to replace them?
Geckos?
The motors are Balder dc servos at approx 80 volt, 5A.
Any help greatly appreciated.
Iain
Discussion Thread
hllrsr@c...
2002-11-03 12:33:23 UTC
Refitting a Lynx
Jon Elson
2002-11-03 22:15:45 UTC
Re: [CAD_CAM_EDM_DRO] Refitting a Lynx