Re: RE: (unknown) g43-44
Posted by
Ray Henry
on 2002-11-03 17:38:11 UTC
Tim
I seem to recall something about there being a difference in the function
of these g-codes on this side of the pond from the way that they are used
on the other side.
Ray
I seem to recall something about there being a difference in the function
of these g-codes on this side of the pond from the way that they are used
on the other side.
Ray
> From: "Tim Goldstein" <timg@...>
> Subject: RE: (unknown)
>
> G43 is tool length offset. Not sure on G44
>
> Tim
> [Denver CO]
>
> > -----Original Message-----
> >
> > hi all
> >
> > what is g43/44 for?
> >
> > JS
> >