Maxnc 70 oz/in system under powered
Posted by
rgcasteel
on 2002-11-04 13:59:13 UTC
In searching for an e-mail address for Maxnc, I found this and other
Yahoo groups sharing their experiences.
I own and have used the Maxnc 70 oz/in 3 axis motion control for some
time. It is installed on a 16"x16"x6" router. I use DesignCad
exporting DXF to Bobcad to create G codes. I'm quite pleased with
work in both wood and sign vinyl cutting. I'm Ok with the Maxnc
system my only wish is for more stepper power.
Can my system be souped-up? More voltage? Larger steppers?
I would appreciate your suggestions or instructions for this upgrade.
Yahoo groups sharing their experiences.
I own and have used the Maxnc 70 oz/in 3 axis motion control for some
time. It is installed on a 16"x16"x6" router. I use DesignCad
exporting DXF to Bobcad to create G codes. I'm quite pleased with
work in both wood and sign vinyl cutting. I'm Ok with the Maxnc
system my only wish is for more stepper power.
Can my system be souped-up? More voltage? Larger steppers?
I would appreciate your suggestions or instructions for this upgrade.