Re: [CAD_CAM_EDM_DRO] Conversational CNC

Hi Brian,

This sounds like a good place to start. Perhaps you could post a .ZIP
file in our files section, OR, you can send them to me direct. KM6VV
-at- ARRL dot Net

Thanks!

Alan KM6VV

Brian wrote:

>
> Hi, i have Autoedit and its not conversational, just a code writing helper.
> A good example of conversational , first you have commands like loop,do this
> x number times, repeat with new location, start position, routines that ask
> questions and writes code. I can send you a small batch of dos cam programs,
> which if were tied together with some user interface would make a
> conversational program. each operates as if it is a conversational program.i
> use them to make code, then append them into another program of code.
> Example, i use the makepocket routine, start at location ,x,y (to make a
> slot in a piece of wood for a lock corner box. then g-53 move zero location
> (amount between fingers)repeat the makepocket routine untill i have made all
> the slots on one end of the wood, then g-53 for the other end so the space
> is where a finger was on the other end.
> if you want to try the dos routines you'll soon get the idea of
> conversational. they are less than 1 meg for all of them, and will run from
> windows in dos. cul brian f.
> ----- Original Message -----
> From: <wanliker@...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Tuesday, November 05, 2002 10:05 PM
> Subject: [CAD_CAM_EDM_DRO] Conversational CNC
>
> > Would someone on the list that has used AutoEdit CNC tell me if that is a
> > conversational CNC program.
> > Or would someone care to download it and check it out with the same
> question.
> >
> > It has a series of windows that you fill in the parameters and it
> > automatically writes the G code, also has simulate. This code then can be
> > saved and I believe ran.
> >
> > Is this what conversational CNC is?????????? Or is it just a code
> > editor???????
> >
> > thanks,
> > bill