Re: need simple software to run single axis - dividing ...

--- In CAD_CAM_EDM_DRO@y..., wanliker@a... wrote:

> In a message dated 11/13/2002 11:26:52 AM Mountain Standard Time,
> machines@n... writes:
>
>
> > Would this application suit your needs?
> > http://www.divisionmaster.com
> >
>
> At 250 pounds it is an expensive device.
> bill
>
>

Exactly the same price as Indexer LTP that's being touted around
plus you don't need a PC and have to write the software for it.
It was just a heads up, it's not my decision. Some people like an out
the box answer to things.
I must admit to owning one of these and find it very handy. I'm in
the process of building an electronic gear hobber and I wanted a 32
to 125 tooth timing belt pulley set up tonight to convert a 1024
count shaft encoder to 4000 counts. With no setup hassle at all I
machined these two sets up from pre machined blanks in just slightly
under the hour. As a 125 T wheel isn't a standard item but if it was
it would be about 32 UKP and the 32 is 8 UKP That's 40 UKP per set.
So basically for an hours work tonight I saved 80 UKP, about $124
Soon get that back.

John S.