My first post here: Converting my mill - 10 of these questions a day?
Posted by
nicolas_jns
on 2002-11-28 12:11:22 UTC
Hi from me!
I would like to have some help on this one. As usual.
Here is the mill (and the 3 axis) I'm going to convert:
[img]http://www.hydroplate.netfirms.com/the mill.jpg[/img]
I'm going to start with only the X and Y axis and do the vertical
feeding by hand.
Any suggestions on steppermotors and drivers, etc.?
/Nicolas Jonasson
I would like to have some help on this one. As usual.
Here is the mill (and the 3 axis) I'm going to convert:
[img]http://www.hydroplate.netfirms.com/the mill.jpg[/img]
I'm going to start with only the X and Y axis and do the vertical
feeding by hand.
Any suggestions on steppermotors and drivers, etc.?
/Nicolas Jonasson
Discussion Thread
nicolas_jns
2002-11-28 12:11:22 UTC
My first post here: Converting my mill - 10 of these questions a day?