Re: [CAD_CAM_EDM_DRO] Accuracy of Step/Dir Driven Brushless Servos
Posted by
cnc002@a...
on 2002-12-09 05:23:52 UTC
In a message dated 12/7/2002 9:13:02 PM Eastern Standard Time,
mark@... writes:
You might want to take a closer look at those amplifier / drives. The ones
you already have very well may take step/direction inputs already without the
need for another board. I know a lot of the brushless systems do this, I am
more familiar with Emerson brushless and I know the ones I have used of
theirs does this.
Randy
[Non-text portions of this message have been removed]
mark@... writes:
> I really need some input. Does anyone have any experience withMark:
> driving brushless servo motors with Step/Dir signals? My plan is to
> use the Rutex 997 board that inputs step/dir signals from the
> parallel port and outputs the 0-10v signal to my Aerotech drives.
> The Rutex board also receives encoder feedback. My question is: Am I
> sacrificing accuracy with this approach? (or anything else?) Also,
> will my encoder feedback go to both the Rutex board as well as the
> drive/amp because the amp has encoder input too. Any feedback
> greatly appreciated!
>
> Mark
>
You might want to take a closer look at those amplifier / drives. The ones
you already have very well may take step/direction inputs already without the
need for another board. I know a lot of the brushless systems do this, I am
more familiar with Emerson brushless and I know the ones I have used of
theirs does this.
Randy
[Non-text portions of this message have been removed]
Discussion Thread
natchamp_87 <mark@h...
2002-12-07 18:11:53 UTC
Accuracy of Step/Dir Driven Brushless Servos
natchamp_87 <mark@h...
2002-12-08 09:25:40 UTC
Re: Accuracy of Step/Dir Driven Brushless Servos
Tim Goldstein
2002-12-08 09:55:12 UTC
RE: [CAD_CAM_EDM_DRO] Re: Accuracy of Step/Dir Driven Brushless Servos
Eric Keller
2002-12-08 12:23:05 UTC
Accuracy of Step/Dir Driven Brushless Servos
natchamp_87 <mark@h...
2002-12-08 18:58:43 UTC
Re: Accuracy of Step/Dir Driven Brushless Servos
cnc002@a...
2002-12-09 05:23:52 UTC
Re: [CAD_CAM_EDM_DRO] Accuracy of Step/Dir Driven Brushless Servos