Gecko VS BP series 1
Posted by
yours_salman2002 <salman1250@h...
on 2002-12-14 06:09:57 UTC
I have a machine (bridgeport series1 cnc).it's stepper is (model
SIGMA and i think 8 AMP,56 VOLTS per coil resistence is 0.6OHM.
EightWire motor).did (G201)can drive perfectly this motor .plz tell
me , can i connect this motor direct to drive or i use wire wound
resistence in series of coils?.
i see a another bridgeport milling machine as i say above,that uses
(G201)drives working very well.
salman hameed.
SALMAN ENGINEERING WORKS
SIGMA and i think 8 AMP,56 VOLTS per coil resistence is 0.6OHM.
EightWire motor).did (G201)can drive perfectly this motor .plz tell
me , can i connect this motor direct to drive or i use wire wound
resistence in series of coils?.
i see a another bridgeport milling machine as i say above,that uses
(G201)drives working very well.
salman hameed.
SALMAN ENGINEERING WORKS