Re: Linux EMC project

As far as the stepper controller board goes, I would make a strong
recomendation for getting it from Dan at Camtronics
http://www.seanet.com/~dmauch/
I am using one I built from his 5 amp kit and am very pleased.

Tim
[Denver, CO]

----- Original Message -----
From: Buchanan, James (Jim) <jambuch@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Wednesday, June 02, 1999 2:00 PM
Subject: Re: [CAD_CAM_EDM_DRO] Linux EMC project


> From: "Buchanan, James (Jim)" <jambuch@...>
>
> Where do I get a copy of EMC? What is the best source of a stepper
> control board?
> --
> James Buchanan
> Lexington, Kentucky (The Blue Grass State) USA
> Two Truck Climax Locomotive Operator & Builder
>
> ------------------------------------------------------------------------
> With more than 18 million e-mails exchanged daily...
> http://www.onelist.com
> ...ONElist is THE place where the world talks!
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
discussion of shop built systems in the above catagories.
>