Nuts and Volts CNC DIY
on 2002-12-24 14:30:53 UTC
Hi
Does anyone know when the article on the CNC conversion of a mill
using
steppers and Gecko drivers that was suppose to be in the November
edition and then resheduled for the December edition of Nuts and Volts
will be again scheduled ?
I live in New Zealand and got the magazine sent to me and was
dissapointed to find it was not in there.
Regards
Sam
Does anyone know when the article on the CNC conversion of a mill
using
steppers and Gecko drivers that was suppose to be in the November
edition and then resheduled for the December edition of Nuts and Volts
will be again scheduled ?
I live in New Zealand and got the magazine sent to me and was
dissapointed to find it was not in there.
Regards
Sam