Re: [CAD_CAM_EDM_DRO] Spindle Wizard 3 Axis Mill

In a message dated 12/29/2002 5:47:28 PM Eastern Standard Time,
godsone@... writes:

> 3100947741

Just my $.02 , It appears to have the familiar blue sy-lo sync 1100 " /oz
stepper motors on it

from what I can see of the y axis. If the machine will clean up nicely with
some elbow grease and if the ways are reasonable, you got a very good deal.

I hope you have a lot of good friends & a pallet jack to move it.

or you could rent a fork lift.

My mill that I got off of ebay weight in at 3200 lbs.

found out who my friends were fast.

you may want to wire the motor windings in series.

I took a set of the same type off stepper motors off of a plate maker. they
used an R/L type drive and got real hot.

don


[Non-text portions of this message have been removed]