Re: [CAD_CAM_EDM_DRO] Help with encoder

What brand are the encoders. I have so far been able to find the
manufacturer spec sheets with a little web searching.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
www.KTMarketing.com/Sherline
www.KTMarketing.com/DeskCNC

----- Original Message -----

> I have Gecko 340's. I have 500 line rotary encoders on my servos.
> The color code of the encoder wires is Red, Black, Yel, Wht, Org, Blu
> and Brn. I put the motor on the bench and with a scope determined
> that (as expected) red is +5, blk is Gnd and that I had out of phase
> signals on the yel-blu set. The wht-org set are from what I can tell
> the differential outputs of the A and B (?) The other wire are INdex
> and signal grounds.