Re: Step motor turns only 1 way
Posted by
Tony Jeffree
on 2003-01-03 01:59:03 UTC
At 09:21 03/01/2003 +0000, you wrote:
direction pins. You need to go back into the axis configuration menu in
Turbo CNC & check that what you have set there is correct. I have a working
TurboCNC "INI" file that definitely drives in both directions on all 3 axes
with a Xylotex card. If you still have problems, I can mail you it offline.
(I assume that you are using the Xylotex D25 ribbon cable/connector - if
not, the other possibility is that you have mis-connected the direction pins.)
Regards,
Tony
>Hi everyone, I've just set up my Xylotex drive with my 6 wireMy guess is that you have not set up the right configuration for the
>2amp/phase motors wired in full-winding mode. I'm using TurboCNC to
>just see if the motors turn. I can jog the motor, but it will only
>turn in one direction. If I jog the motor in the opposite direction,
>it still turns, but still in the same direction. Any idea what's
>wrong? Thanks in advance.
direction pins. You need to go back into the axis configuration menu in
Turbo CNC & check that what you have set there is correct. I have a working
TurboCNC "INI" file that definitely drives in both directions on all 3 axes
with a Xylotex card. If you still have problems, I can mail you it offline.
(I assume that you are using the Xylotex D25 ribbon cable/connector - if
not, the other possibility is that you have mis-connected the direction pins.)
Regards,
Tony
Discussion Thread
builder4wd <builder4wd@y...
2003-01-03 01:21:53 UTC
Step motor turns only 1 way
Tony Jeffree
2003-01-03 01:59:03 UTC
Re: Step motor turns only 1 way