Re: Shinano Kenshi Steppers
Posted by
Don Hughes
on 1999-06-02 20:20:12 UTC
> The four motors are set up with center tapped windings. An ohmmeterWell I did this and all the wire combinations that passed the continuity
> should tell you which groups of 3 are connected to the same winding, then
> a little more probing with the ohmmeter will tell you which lead is the
> center tap. (The leads which have the most resistance of any combination
> are the end 2 wires, the remaining one must be the center tap.)
test have all the same resistance. What I have found out is that there
are two sets of red wires, one with a white tracer on it, and a black
wire that mate up. The other set is two green wires, one with a whit
tracer on it, and a white wire that mate up. But as far as ohms go, they
all seem to have the same, so finding the center tap is difficult. Any
other suggestions Jon?
Thanks again,
Don Hughes
Vancouver, BC Canada
Discussion Thread
Don Hughes
1999-06-02 13:31:53 UTC
Shinano Kenshi Steppers
Jon Elson
1999-06-02 14:25:35 UTC
Re: Shinano Kenshi Steppers
Don Hughes
1999-06-02 14:52:58 UTC
Re: Shinano Kenshi Steppers
Don Hughes
1999-06-02 20:20:12 UTC
Re: Shinano Kenshi Steppers
DRigotti@x...
1999-06-02 20:26:30 UTC
Re: Shinano Kenshi Steppers
Don Hughes
1999-06-02 20:36:59 UTC
Re: Shinano Kenshi Steppers
William Scalione
1999-06-02 21:22:31 UTC
Re: Shinano Kenshi Steppers
Don Hughes
1999-06-02 21:30:10 UTC
Re: Shinano Kenshi Steppers
William Scalione
1999-06-02 22:28:18 UTC
Re: Shinano Kenshi Steppers