Fanuc OT controler Tool changes
Posted by
mark taft hotmail
on 2003-01-07 10:09:47 UTC
Hi Everyone,
Does anyone know how to display large text messages on the Fanuc OT Controller.
I wish to display a message each time a tool is to be changed on our Colchester 2000L manual tool change lathe.
Or, is it not possible on this older controller.
I have scoured the manuals with no success.
Cheers
Mark
[Non-text portions of this message have been removed]
Does anyone know how to display large text messages on the Fanuc OT Controller.
I wish to display a message each time a tool is to be changed on our Colchester 2000L manual tool change lathe.
Or, is it not possible on this older controller.
I have scoured the manuals with no success.
Cheers
Mark
[Non-text portions of this message have been removed]