plunging endmill This Subject is Off Topic....................
Posted by
wanliker@a...
on 2003-02-03 17:31:47 UTC
This is the wrong group for that subject, this group is restricted to
building modifying equipment only.
If you look at the bottom of each message you will see a sister group, and
that is the correct place for this subject.
This group is really not concerned with the general operating of the
equipment such as feed, speeds, take that to the sister group.
Any replies off list to any of the moderators only.............
bill
List Mom
building modifying equipment only.
If you look at the bottom of each message you will see a sister group, and
that is the correct place for this subject.
This group is really not concerned with the general operating of the
equipment such as feed, speeds, take that to the sister group.
Any replies off list to any of the moderators only.............
bill
List Mom
Discussion Thread
wanliker@a...
2003-02-03 17:31:47 UTC
plunging endmill This Subject is Off Topic....................