CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: Old CNC controls

Posted by D.F.S.
on 2000-02-23 15:56:16 UTC
>
> From: ptengin@...
>
> In a message dated 02/23/2000 10:23:47 AM Hawaiian Standard Time,
> dfs@... writes:
>
> << What speed is the motor rated at for 220V & 60 Hz?
>
> ~1,700, ~3,400 something else?
>
> I presume this is a standard 3 phase motor?
>
> Marc >>
> Marc,
> It is a 1725 open drip proof 3hp 3 phase motor as purchased from WW
> Grainger. I have a 1.5 to 1 step up on the spindle so the motor RPM's are
> actually about 35 to 2300 or so. I don't want to overspeed the motor too much!

Boy, that is quite a range, I didn't know that much was of a
change was possible.

Thanks.

I'm going to look at going that route with my lathe.

Marc

Discussion Thread

Jon Elson 2000-02-21 21:54:10 UTC Re: Old CNC controls D.F.S. 2000-02-22 09:27:45 UTC Re: Re: Old CNC controls Jon Elson 2000-02-22 22:12:37 UTC Re: Re: Old CNC controls Eric Keller 2000-02-22 09:15:10 UTC Re: Re: Old CNC controls D.F.S. 2000-02-23 09:45:59 UTC Re: Re: Old CNC controls ptengin@a... 2000-02-23 11:35:20 UTC Re: Re: Old CNC controls D.F.S. 2000-02-23 12:11:31 UTC Re: Re: Old CNC controls ptengin@a... 2000-02-23 15:29:36 UTC Re: Re: Old CNC controls D.F.S. 2000-02-23 15:56:16 UTC Re: Re: Old CNC controls Jon Elson 2000-02-23 22:26:21 UTC Re: Re: Old CNC controls Fred Smith 2000-02-24 05:56:35 UTC Re: Re: Old CNC controls Matt Shaver 2000-02-24 07:09:37 UTC Re: Re: Old CNC controls