Dro
Posted by
Terry May
on 2000-02-22 16:31:00 UTC
For Art Eckstein,
Art I read your post on the 9th about the servo motors you bought
from Goldmine Electronics and thought it sounded good. I ordered some
and just got them in yesterday. I'm am very interested in any details
you care to share about your installation and I have a couple of
questions right off the bat. First you mentioned getting bearings for
the motor shafts from goldmine also, is this the bearing in their
catalog numbered G1558 that they say has an ID of 7/32"? It's the
only one I saw in their catalog. My other immediate question is which
colors on the encoder leads correspond to the A & B outputs on the
Linsay schematic? My motors have red and black which I assume are pwr
and grd and also blue and yellow leads.
Again I would appreciate any info you may be willing to share. If
you prefer to go off-list my email is tmay@....
By the way if anyone else is interested Goldmine also has another
motor with a physically smaller encoder but it is only 400 lines.
Thanks
Terry
Thanks
Art I read your post on the 9th about the servo motors you bought
from Goldmine Electronics and thought it sounded good. I ordered some
and just got them in yesterday. I'm am very interested in any details
you care to share about your installation and I have a couple of
questions right off the bat. First you mentioned getting bearings for
the motor shafts from goldmine also, is this the bearing in their
catalog numbered G1558 that they say has an ID of 7/32"? It's the
only one I saw in their catalog. My other immediate question is which
colors on the encoder leads correspond to the A & B outputs on the
Linsay schematic? My motors have red and black which I assume are pwr
and grd and also blue and yellow leads.
Again I would appreciate any info you may be willing to share. If
you prefer to go off-list my email is tmay@....
By the way if anyone else is interested Goldmine also has another
motor with a physically smaller encoder but it is only 400 lines.
Thanks
Terry
Thanks
Discussion Thread
Terry May
2000-02-22 16:31:00 UTC
Dro
wanliker@a...
2000-02-24 23:16:44 UTC
Re: Dro
A. G. Eckstein
2000-02-25 16:14:55 UTC
Re: Dro
A. G. Eckstein
2000-02-25 16:26:44 UTC
Re: Dro
Roni51723@a...
2000-11-15 11:16:19 UTC
Dro
Alan Marconett KM6VV
2000-11-15 16:08:30 UTC
Re: [CAD_CAM_EDM_DRO] Dro