[CAD_CAM_EDM_DRO] Control cable
Posted by
Doug Fortune
on 2003-03-11 22:26:17 UTC
"P. J. Hicks" wrote:
Subject: Re: [CAD_CAM_EDM_DRO] Motor cable
Try
http://www.mcmaster.com/
refer to page 680 or do a search for "flexible control cable"
At 11:16 AM 1/6/2003 -0800, you wrote:
Doug Fortune
http://www.cncKITS.com
.
>This was written 06-Jan-2003:
> Hi guys,
>
> Several months ago there was some discussion and some links posted to a source for 'surplus control cable'. I have lost that link and can't seem to find them by searching the archives. Anyone remember ?
Subject: Re: [CAD_CAM_EDM_DRO] Motor cable
Try
http://www.mcmaster.com/
refer to page 680 or do a search for "flexible control cable"
At 11:16 AM 1/6/2003 -0800, you wrote:
>Hi,Don't know if that helps...
>I have my Sherline/Xylotex/Mach1 system up and running.....finally! The
>cable I found and used for the leads to the motors from the driver is 4
>conductor, foil shielded with a ground lead next to the shield. The problem
>is that this cable is not very flexible.
>Any suggestions for a more flexible cable and where to get it? I would like
>to get enough and of a suitable size that I can use it on my BP size
>mill/drill later on. I will probably use steppers on it also.
>
>Thanks, PJH
Doug Fortune
http://www.cncKITS.com
.
Discussion Thread
P. J. Hicks
2003-03-11 20:34:45 UTC
Control cable
Doug Fortune
2003-03-11 22:26:17 UTC
[CAD_CAM_EDM_DRO] Control cable
Randy Gordon-Gilmore
2003-03-12 09:51:48 UTC
Re: Control cable