Re: [CAD_CAM_EDM_DRO]servo motors
Posted by
Art Eckstein
on 2003-03-20 09:02:25 UTC
Bob,
In most cases, I would say YES as they develop their full potential at a
higher rpm. Unlike steppers that develop their torque at low speeds.
At 08:12 AM 3/20/03 -0800, you wrote:
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
LaGrange, GA
http://ns1.dicomm.net/~axtein/dro
[Non-text portions of this message have been removed]
In most cases, I would say YES as they develop their full potential at a
higher rpm. Unlike steppers that develop their torque at low speeds.
At 08:12 AM 3/20/03 -0800, you wrote:
>I have a question on servo motors.Bubba
>
>Do most servo motors require a belt drive reduction or are they set up for
>direct drive?
>
>Bob Campbell
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
LaGrange, GA
http://ns1.dicomm.net/~axtein/dro
[Non-text portions of this message have been removed]
Discussion Thread
Larry Van Duyn
2000-08-29 13:34:23 UTC
servo motors
Jon Elson
2001-09-08 22:04:19 UTC
Re: [CAD_CAM_EDM_DRO] servo motors
M. SHABBIR
2001-09-09 06:07:47 UTC
Re: [CAD_CAM_EDM_DRO] servo motors
Jon Elson
2001-09-09 14:24:16 UTC
Re: [CAD_CAM_EDM_DRO] servo motors
M. SHABBIR
2001-09-10 18:57:14 UTC
Re: [CAD_CAM_EDM_DRO] servo motors
Jon Elson
2001-09-10 21:51:40 UTC
Re: [CAD_CAM_EDM_DRO] servo motors
Robert Campbell
2003-03-20 08:12:56 UTC
[CAD_CAM_EDM_DRO]servo motors
Art Eckstein
2003-03-20 09:02:25 UTC
Re: [CAD_CAM_EDM_DRO]servo motors
Jon Elson
2003-03-20 09:50:44 UTC
Re: [CAD_CAM_EDM_DRO]servo motors
george_barr
2003-06-26 19:35:57 UTC
servo motors
Jon Elson
2003-06-27 19:06:08 UTC
Re: [CAD_CAM_EDM_DRO] servo motors