gecko 320 drives
Posted by
hamlertools
on 2003-03-22 09:57:03 UTC
I have converted a dyna 2400 mill from steppers to servo. Tuned the
motors using the "Dan Mauch flywheel method with great success". I am
running the mill with the new Flashcut version 2.06 software.This
version gives you 4 option in setting the polarity of the step pulse.
Option 1 step pulse High with the active edge Trailing, option 2 step
pulse low with the active edge trailing, option 3 step pulse high
with the active edge leading and option 4 step pulse low with the
active edge leading. I have the step pulse duration st for 10 Usec.
Is there anyone out there running the Gecko 320 on Flashcut 2.06 that
can suggest the proper option to use.Have requested info fron Gecko
and am awaiting a response .
Thanks
Paul Hamler
motors using the "Dan Mauch flywheel method with great success". I am
running the mill with the new Flashcut version 2.06 software.This
version gives you 4 option in setting the polarity of the step pulse.
Option 1 step pulse High with the active edge Trailing, option 2 step
pulse low with the active edge trailing, option 3 step pulse high
with the active edge leading and option 4 step pulse low with the
active edge leading. I have the step pulse duration st for 10 Usec.
Is there anyone out there running the Gecko 320 on Flashcut 2.06 that
can suggest the proper option to use.Have requested info fron Gecko
and am awaiting a response .
Thanks
Paul Hamler