Re: Ballscrew machining, FAQ
Posted by
ptengin@a...
on 2000-02-27 03:08:55 UTC
In a message dated 02/26/2000 2:35:59 PM Hawaiian Standard Time,
stratton@... writes:
<< What is the gripping range of a 5c collet
anyway? >>
I would not go ore than +-.005"
Peter
THRD, Inc.
stratton@... writes:
<< What is the gripping range of a 5c collet
anyway? >>
I would not go ore than +-.005"
Peter
THRD, Inc.
Discussion Thread
stratton@m...
2000-02-26 16:35:14 UTC
Ballscrew machining, FAQ
Ian Wright
2000-02-27 02:26:43 UTC
Re: Ballscrew machining, FAQ
ptengin@a...
2000-02-27 03:03:58 UTC
Re: Ballscrew machining, FAQ
ptengin@a...
2000-02-27 03:08:55 UTC
Re: Ballscrew machining, FAQ
Les Watts
2000-02-27 06:29:16 UTC
Re: Ballscrew machining, FAQ
Charles Hopkins
2000-02-27 08:14:21 UTC
RE: Ballscrew machining, FAQ