Re: CNC routing cutting extruded acrylic
Posted by
Neil Gillies
on 2003-03-28 08:00:28 UTC
Hi Russ
Curiously, I was doing the same thing only last Saturday :-))
Lots of compressed air directed at the cutter works a treat - make sure
you're out of the general area and that the parts are well stuck down :-)
Option is to use cast rather than extruded acrylic - males a nicer cut.
Cheers
Neil
___________________________________________________________________________
Neil D. Gillies Tel: +44 (0)1383-823489
iGull Technologies Fax: +44 (0)8707-059481
11 River View Mobile: +44 (0)771-4330793
Dalgety Bay, Fife neil@...
Scotland KY11 9YE http://www.igull.co.uk
http://www.sea-gull.demon.co.uk
Curiously, I was doing the same thing only last Saturday :-))
Lots of compressed air directed at the cutter works a treat - make sure
you're out of the general area and that the parts are well stuck down :-)
Option is to use cast rather than extruded acrylic - males a nicer cut.
Cheers
Neil
___________________________________________________________________________
Neil D. Gillies Tel: +44 (0)1383-823489
iGull Technologies Fax: +44 (0)8707-059481
11 River View Mobile: +44 (0)771-4330793
Dalgety Bay, Fife neil@...
Scotland KY11 9YE http://www.igull.co.uk
http://www.sea-gull.demon.co.uk