Newbie Help needed
Posted by
hokey_pokey70
on 2003-03-28 09:10:20 UTC
Hey Folks,
Im in need of a beginners level of controller board schematic so I
can set up a CNC router table to make airplane parts and stuff.
I am a beginner at electronics but I can solder and I could probably
etch my own pcb if needed.
Im just looking for a simple 3 or 4 axis controller board plan or
schematic that can use a PC power supply to run 3 steppers.
Thanks!
Regards,
Rich
Im in need of a beginners level of controller board schematic so I
can set up a CNC router table to make airplane parts and stuff.
I am a beginner at electronics but I can solder and I could probably
etch my own pcb if needed.
Im just looking for a simple 3 or 4 axis controller board plan or
schematic that can use a PC power supply to run 3 steppers.
Thanks!
Regards,
Rich