Re: [CAD_CAM_EDM_DRO] G320 Fault - HCF4029 - Link to picture

Hi Jason,

Doesn't look like anything to worry about, from what I can see in the
pix. This could be the "pin 1" end; sometimes that's the way they mark
that end. Or a notch, dot, etc.

HTH

Alan KM6VV


Jason Cox wrote:

>
> Heres a picture....
>
> http://members.ozemail.com.au/~sinergy/gecko.jpg
>
> Thanks.
>
> ----- Original Message -----
> From: Jason Cox <sinergy@...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Monday, April 07, 2003 4:26 PM
> Subject: [CAD_CAM_EDM_DRO] G320 Fault - HCF4029
>
> > After having a close look at the gecko I noticed a shiny spot on one of
> the
> > IC's, could somebody tell me if this is a sigh that the IC has failed...
> or
> > something else?
> >
> > Can this IC be replaced or is this geck's life over?
> >
> > Thanks again!