Feb 25
Posted by
Darrell Gehlsen
on 2000-03-03 15:07:03 UTC
Got EMC to load to the point that I can get it out of ESTOP and turn the machine on using xemc or the tk interface.
Now when I try to move an axis I get a following error message. I think it is because it is looking for an encoder input (which I do not have).
I am using the frequency mode and minimill io
Darrell
[Non-text portions of this message have been removed]
Now when I try to move an axis I get a following error message. I think it is because it is looking for an encoder input (which I do not have).
I am using the frequency mode and minimill io
Darrell
[Non-text portions of this message have been removed]