Re: [CAD_CAM_EDM_DRO] Feb 25

Darrell Gehlsen wrote:

> From: "Darrell Gehlsen" <dgehlsen@...>
>
> Got EMC to load to the point that I can get it out of ESTOP and turn
> the machine on using xemc or the tk interface.
> Now when I try to move an axis I get a following error message. I
> think it is because it is looking for an encoder input (which I do not
> have).
> I am using the frequency mode and minimill io

You can turn the following error parameter up to a larger value to
prevent
following errors. Or, maybe, it is due to the P gain being too low. If
the
errors only occur at higher speeds, turn up P for each axis to a higher
value.
If it ocurrs at low jog speeds, then turn up the error limit to several
inches.

Jon