Re: [CAD_CAM_EDM_DRO] Built first axis
Posted by
Jon Elson
on 2003-04-22 23:49:56 UTC
starcast82 wrote:
some
NEMA 34 motors. I was running them at 48000 steps/second (the 201A is a x10
microstep drive) so it was running the motor at an equivalent speed of
4800 steps/sec
or 1440 RPM. On the 16 TPI threads of one of the common mini-mills,
that works
out to 90 IPM! But, perhaps you are not using NEMA 34 size motors.
Jon
>on my cnc and I am currently getting a top speed of around 14 inchesWell, I just did some tests with a Gecko 201A with 49 V power supply and
>per minute. I'm wondering if this is in the ballpark. I'm using a
>motor controller I designed and 12 threads per inch acme rod.
>
>
some
NEMA 34 motors. I was running them at 48000 steps/second (the 201A is a x10
microstep drive) so it was running the motor at an equivalent speed of
4800 steps/sec
or 1440 RPM. On the 16 TPI threads of one of the common mini-mills,
that works
out to 90 IPM! But, perhaps you are not using NEMA 34 size motors.
Jon
Discussion Thread
Jon Elson
2003-04-22 23:49:56 UTC
Re: [CAD_CAM_EDM_DRO] Built first axis
Jon Elson
2003-04-23 23:37:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Built first axis