CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] It finally came!

Posted by m.d.c
on 2000-03-05 01:24:34 UTC
Tim Goldstein wrote:

> From: "Tim Goldstein" <timg@...>
>
> I have no experience with the unit, but I had sent them 3 or 4 e-mails
>
> asking about the specifics of the kit and never received a reply. Do
> you
> know is the controller a chopper style unit? My guess at the price is
> no,
> but the unit does seem to be decent item for the cost.
>
> Tim
> [Denver, CO]
>
> ----- Original Message -----
> From: Joe Vicars <jvicars@...>
> To: <CAD_CAM_EDM_DRO@onelist.com>
> Sent: Wednesday, March 01, 2000 11:19 AM
> Subject: [CAD_CAM_EDM_DRO] It finally came!
>
> > From: Joe Vicars <jvicars@...>
> >
> > After five weeks of anticipation, I received my 4 axis bipolar
> > driver kit from Oatley Electronics in Australia. This is my first
> board
> > kit and I need some help. Has anyone built one of these?
> > The kit is at http://www.oatleyelectronics.com/stepper.html
> >
> > I should have asked around before I bought it but I wasn't on
> the
> > list at that time, and it was only $48 Australian dollars which is
> about
> > 30 bucks.
> > Input is greatly appreciated.
>
> -----------------------------------
> ------------------------------------
> @Backup-The Easiest Way to Protect and Access your files.
> Automatic backups and off-site storage of your critical data. Install
>
> your FREE trial today and have a chance to WIN a digital camera!
> Click here.
> http://click.egroups.com/1/1830/1/_/423600/_/951932124/
>
> -----------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes
> there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager

yes; I have made about 4 or five of them, I and they are very good
,and I have the original article of the kit, that appeared on
electronics australia magazine their web address is
www.electronicsaustralia.com.au
regards.
mariano.

Discussion Thread

m.d.c 2000-03-05 01:24:34 UTC Re: [CAD_CAM_EDM_DRO] It finally came!