Turbocnc Trouble
Posted by
smitty8002000
on 2003-04-27 14:57:44 UTC
Having some trouble today setting up my tool offsets.
Once I saved all the offsets, in the file section, the program will
not run. So I return to Windows, and check the program for any
problems. It is nothing more than ZERO's now! I then re-loaded the
program from the floppy, and tried again, same results. Tried
numerous times with no change, I then tried just saving the offsets
and not LOADING them, same results.
Now, as you can see I am very new to this. Do I need to save each
tool seperatly, as I was saving all three at the same time.
What could I be doing wrong, I have little hair left, and would like
to keep what I do have.
Thanks for any help you may offer,
Smitty
Once I saved all the offsets, in the file section, the program will
not run. So I return to Windows, and check the program for any
problems. It is nothing more than ZERO's now! I then re-loaded the
program from the floppy, and tried again, same results. Tried
numerous times with no change, I then tried just saving the offsets
and not LOADING them, same results.
Now, as you can see I am very new to this. Do I need to save each
tool seperatly, as I was saving all three at the same time.
What could I be doing wrong, I have little hair left, and would like
to keep what I do have.
Thanks for any help you may offer,
Smitty
Discussion Thread
smitty8002000
2003-04-27 14:57:44 UTC
Turbocnc Trouble
turbulatordude
2003-04-27 15:57:45 UTC
Re: Turbocnc Trouble