CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: About to start building a CNC wood router

on 2003-05-09 23:30:17 UTC
>
>
>Assuming you have internet access, you can order many items you may need
>from:
>
>
>http://www.mcmaster.com
>

I had wondered if McMaster-Carr was online...I've been referred to them,
Enco, and Grainger
so far. Of course, once they were mentioned, I remembered all of their
names! ;-)

Thank you ALL for so many good suggestions for parts suppliers. And for
so many other suggestions, too.

I don't want to put an end to the discussions -- please, keep going! My
cutting surface will be in the neighborhood of 12x18 inches, in my
latest revision of my design. Moving gantry, fixed table. I think that
this is an achievable goal, and yet still small enough to fit in my
garage/shop, easily. (Version 1 Revision .01 OK, so I'm a software
guy, and I'm already planning revisions and upgrades!) I'm going to
keep in mind everyone's suggestions to build for larger components...and
to plan improvements into the design. Excellent suggestions, all.

-- Chuck Knight

Discussion Thread

Charles Knight 2003-05-09 23:30:17 UTC Re: [CAD_CAM_EDM_DRO] Re: About to start building a CNC wood router